NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 468

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
snmp-server enable traps linkmode
Note: This command may not be available on all platforms.
This command enables Link Up/Down traps for the entire switch. When enabled, link traps are
sent only if the Link Trap flag setting associated with the port is enabled. See
status" on page 7-55
Default enabled
Format
snmp-server enable traps linkmode
Mode Global Config
no snmp-server enable traps linkmode
This command disables Link Up/Down traps for the entire switch.
Format
no snmp-server enable traps linkmode
Mode Global Config
snmp-server enable traps multiusers
This command enables Multiple User traps. When the traps are enabled, a Multiple User Trap is
sent when a user logs in to the terminal interface (EIA 232 or Telnet) and there is an existing
terminal interface session.
Default enabled
Format
snmp-server enable traps multiusers
Mode Global Config
no snmp-server enable traps multiusers
This command disables Multiple User traps.
Format
no snmp-server enable traps multiusers
Mode Global Config
Management Commands
v1.0, November 2010
"snmp trap link-
7-52