NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 129

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Format
no storm-control multicast rate
Mode Interface Config
storm-control multicast (Global)
This command enables multicast storm recovery mode for all interfaces. If the mode is enabled,
multicast storm recovery is active, and if the rate of L2 multicast traffic ingressing on an interface
increases beyond the configured threshold, the traffic will be dropped. Therefore, the rate of
multicast traffic will be limited to the configured threshold.
Default disabled
Format
storm-control multicast
Mode Global Config
no storm-control multicast
This command disables multicast storm recovery mode for all interfaces.
Format
no storm-control multicast
Mode Global Config
storm-control multicast level (Global)
This command configures the multicast storm recovery threshold for all interfaces as a percentage
of link speed and enables multicast storm recovery mode. If the mode is enabled, multicast storm
recovery is active, and if the rate of L2 multicast traffic ingressing on an interface increases
beyond the configured threshold, the traffic will be dropped. Therefore, the rate of multicast traffic
will be limited to the configured threshold.
Default 5
Format
storm-control multicast level <0-100>
Mode Global Config
Switching Commands
v1.0, November 2010
3-88