NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 169

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
ip verify source
Use this command to configure the IPSG source ID attribute to filter the data traffic in the
hardware. Source ID is the combination of IP address and MAC address. Normal command allows
data traffic filtration based on the IP address. With the "port-security" option, the data traffic will
be filtered based on the IP and MAC addresses.
Default
the source ID is the IP address
Format
ip verify source {port-security}
Mode Interface Config
no ip verify source
Use this command to disable the IPSG configuration in the hardware. You cannot disable port-
security alone if it is configured.
Format
no ip verify source
Mode Interface Config
show ip dhcp snooping
Use this command to display the DHCP Snooping global configurations and per port
configurations.
Format
show ip dhcp snooping
Mode • Privileged EXEC
• User EXEC
Term Definition
Interface The interface for which data is displayed.
Trusted If it is enabled, DHCP snooping considers the port as trusted. The factory default is
disabled.
Log Invalid Pkts If it is enabled, DHCP snooping application logs invalid packets on the specified
interface.
Switching Commands
v1.0, November 2010
3-128