Mac Access Control List (Acl) Commands - NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
show service-policy
This command displays a summary of policy-oriented statistics information for all interfaces in the
specified direction.
Format
show service-policy in
Mode Privileged EXEC
The following information is repeated for each interface and direction (only those interfaces
configured with an attached policy are shown):
Term Definition
Interface Valid slot and port number separated by forward slashes.
Operational The current operational status of this DiffServ service interface.
Status
Policy Name The name of the policy attached to the interface.

MAC Access Control List (ACL) Commands

This section describes the commands you use to configure MAC ACL settings. MAC ACLs
ensure that only authorized users have access to specific resources and block any unwarranted
attempts to reach network resources.
The following rules apply to MAC ACLs:
• The maximum number of ACLs you can create is hardware dependent. The limit applies to all
ACLs, regardless of type.
• The system supports only Ethernet II frame types.
• The maximum number of rules per MAC ACL is hardware dependent.
mac access-list extended
This command creates a MAC Access Control List (ACL) identified by <name>, consisting of
classification fields defined for the Layer 2 header of an Ethernet frame. The <name> parameter
is a case-sensitive alphanumeric string from 1 to 31 characters uniquely identifying the MAC
access list.
Quality of Service (QoS) Commands
v1.0, November 2010
5-33