NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 130

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
no storm-control multicast level
This command sets the multicast storm recovery threshold to the default value for all interfaces
and disables multicast storm recovery.
Format
no storm-control multicast level
Mode Global Config
storm-control multicast rate (Global)
Use this command to configure the multicast storm recovery threshold for all interfaces in packets
per second. If the mode is enabled, multicast storm recovery is active, and if the rate of L2
broadcast traffic ingressing on an interface increases beyond the configured threshold, the traffic is
dropped. Therefore, the rate of multicast traffic is limited to the configured threshold.
Default 0
Format
storm-control multicast rate <0-14880000>
Mode Global Config
no storm-control broadcast rate
This command sets the broadcast storm recovery threshold to the default value for all interfaces
and disables broadcast storm recovery.
Format
no storm-control broadcast rate
Mode Global Config
storm-control unicast
This command enables unicast storm recovery mode for an interface. If the mode is enabled,
unicast storm recovery is active, and if the rate of unknown L2 unicast (destination lookup failure)
traffic ingressing on an interface increases beyond the configured threshold, the traffic will be
dropped. Therefore, the rate of unknown unicast traffic will be limited to the configured threshold.
Switching Commands
v1.0, November 2010
3-89