NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 113

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Default • guest-vlan-period: 90 seconds
• reauth-period: 3600 seconds
• quiet-period: 60 seconds
• tx-period: 30 seconds
• supp-timeout: 30 seconds
• server-timeout: 30 seconds
Format
dot1x timeout {{guest-vlan-period <seconds>} |{reauth-period
<seconds>} | {quiet-period <seconds>} | {tx-period <seconds>} |
{supp-timeout <seconds>} | {server-timeout <seconds>}}
Mode Interface Config
no dot1x timeout
This command sets the value, in seconds, of the timer used by the authenticator state machine on
this port to the default values. Depending on the token used, the corresponding default values are
set.
Format
no dot1x timeout {guest-vlan-period | reauth-period | quiet-period |
tx-period | supp-timeout | server-timeout}
Mode Interface Config
dot1x unauthenticated-vlan
Use this command to configure the unauthenticated VLAN associated with that port. The
unauthenticated VLAN ID can be a valid VLAN ID from 0-Maximum supported VLAN ID (4093
for 7000 series). The unauthenticated VLAN must be statically configured in the VLAN database
to be operational. By default, the unauthenticated VLAN is 0, i.e. invalid and not operational.
Default 0
Format
dot1x unauthenticated-vlan <vlan id>
Mode Interface Config
no dot1x unauthenticated-vlan
This command resets the unauthenticated-vlan associated with the port to its default value.
Switching Commands
v1.0, November 2010
3-72