NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 472

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
snmp trap link-status all
This command enables link status traps for all interfaces.
Note: This command is valid only when the Link Up/Down Flag is enabled. See
server enable traps linkmode" on page 7-52
Format
snmp trap link-status all
Mode Global Config
no snmp trap link-status all
This command disables link status traps for all interfaces.
Note: This command is valid only when the Link Up/Down Flag is enabled. See
server enable traps linkmode" on page 7-52
Format
no snmp trap link-status all
Mode Global Config
show snmpcommunity
This command displays SNMP community information. Six communities are supported. You can
add, change, or delete communities. The switch does not have to be reset for changes to take
effect.
The SNMP agent of the switch complies with SNMP Versions 1, 2 or 3. For more information
about the SNMP specification, see the SNMP RFCs. The SNMP agent sends traps through TCP/IP
to an external SNMP manager based on the SNMP configuration (the trap receiver and other
SNMP community parameters).
Format
show snmpcommunity
Mode Privileged EXEC
Management Commands
v1.0, November 2010
"snmp-
"snmp-
7-56