Icmp Throttling Commands - NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
no ip helper-address discard
Use this command to permit the matching packets.
Format
no ip helper-address discard
{<1-65535>|dhcp|domain|isakmp|mobile-ip|nameserver|
netbios-dgm|netbios-ns|ntp|pim-auto-rip|rip|tacacs|tftp|time}
Mode Interface Config
show ip helper-address
Use this command to display the configured helper addresses on the given interface.
Format
show ip helper-address <interface>
Mode • Privileged EXEC
• User EXEC
The following shows example CLI display output for the command.
(switch) #show ip helper-address 1/0/1
Helper IP Address.............................. 1.2.3.4
............................................... 1.2.3.5

ICMP Throttling Commands

This section describes the commands you use to configure options for the transmission of various
types of ICMP messages.
ip unreachables
Use this command to enable the generation of ICMP Destination Unreachable messages. By
default, the generation of ICMP Destination Unreachable messages is enabled.
Default enable
Format
ip unreachables
Mode Interface Config
Routing Commands
v1.0, November 2010
4-26