Stack Firmware Synchronization Commands - NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
show checkpoint statistics
This command displays the statistics for the checkpointing process.
Format
show checkpoint statistics
Mode Privileged EXEC
Example:
(Switch)#show checkpoint statistics
Messages Checkpointed.....................6708
Bytes Checkpointed........................894305
Time Since Counters Cleared...............3d 01:05:09
Checkpoint Message Rate...................0.025 msg/sec
Last 10-second Message Rate...............0 msg/sec
Highest 10-second Message Rate............8 msg/sec
clear checkpoint statistics
This command clears the statistics for the checkpointing process.
Format
clear checkpoint statistics
Mode Privileged EXEC

Stack Firmware Synchronization Commands

Stack firmware synchronization provides an automatic mechanism to synchronize the firmware on
stack members whose firmware version differs from the version running on the stack manager.
This operation can result in either an upgrade or downgrade of firmware on the mismatched stack
member. However, this operation does not attempt to synchronize the stack to the latest firmware
in the stack.
During firmware transfer and upgrade, operations such as code download and move management
can result in undesirable behavior, such as firmware corruption on a code mismatched stack
member. As a result, you receive an error if you try to access the following operations from the
user interface during stack firmware synchronization:
• Move management
• Unit renumbering
• Code download
Stacking Commands
v1.0, November 2010
2-14