NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 62

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
spanning-tree mst vlan
This command adds an association between a multiple spanning tree instance and one or more
VLANs so that the VLAN(s) are no longer associated with the common and internal spanning tree.
The parameter <mstid> is a number that corresponds to the desired existing multiple spanning
tree instance. The vlan range can be specified as a list or as a range of values. To specify a list of
VLANs, enter a list of VLAN IDs, each separated by a comma with no spaces in between. To
specify a range of VLANs, separate the beginning and ending VLAN ID with a dash ("-").
Format
spanning-tree mst vlan <mstid> <vlanid>
Mode Global Config
no spanning-tree mst vlan
This command removes an association between a multiple spanning tree instance and one or more
VLANs so that the VLAN(s) are again associated with the common and internal spanning tree.
Format
no spanning-tree mst vlan <mstid> <vlanid>
Mode Global Config
spanning-tree port mode
This command sets the Administrative Switch Port State for this port to enabled.
Default disabled
Format
spanning-tree port mode
Mode Interface Config
no spanning-tree port mode
This command sets the Administrative Switch Port State for this port to disabled.
Format
no spanning-tree port mode
Mode Interface Config
Switching Commands
v1.0, November 2010
3-21