NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 161
Managed stackable switch cli manual, software version 9.0
Hide thumbs
Also See for XSM7224S - ProSafe 10 Gigabit Stackable:
- Hardware installation manual (30 pages) ,
- Installation manual (2 pages) ,
- User manual (740 pages)
Table of Contents
Advertisement
ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
macfilter adddest all
This command adds all interfaces to the destination filter set for the MAC filter with the given
<macaddr> and VLAN of <vlanid>. The <macaddr> parameter must be specified as a 6-
byte hexadecimal number in the format of b1:b2:b3:b4:b5:b6. The <vlanid> parameter must
identify a valid VLAN.
Note: Configuring a destination port list is only valid for multicast MAC addresses.
Format
macfilter adddest all <macaddr> <vlanid>
Mode
Global Config
no macfilter adddest all
This command removes all ports from the destination filter set for the MAC filter with the given
<macaddr> and VLAN of <vlanid>. The <macaddr> parameter must be specified as a 6-
byte hexadecimal number in the format of b1:b2:b3:b4:b5:b6. The <vlanid> parameter must
identify a valid VLAN.
Format
no macfilter adddest all <macaddr> <vlanid>
Mode
Global Config
macfilter addsrc
This command adds the interface to the source filter set for the MAC filter with the MAC address
of <macaddr> and VLAN of <vlanid>. The <macaddr> parameter must be specified as a 6-byte
hexadecimal number in the format of b1:b2:b3:b4:b5:b6. The <vlanid> parameter must identify
a valid VLAN.
Format
macfilter addsrc <macaddr> <vlanid>
Mode
Interface Config
Switching Commands
v1.0, November 2010
3-120
Advertisement
Table of Contents
