NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 248

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
The format of the MAC address is 6 two-digit hexadecimal numbers that are separated by colons,
for example 00:06:29:32:81:40.
Format
arp <ipaddress> <macaddr>
Mode Global Config
no arp
This command deletes an ARP entry. The value for <arpentry> is the IP address of the
interface. The value for <ipaddress> is the IP address of a device on a subnet attached to an
existing routing interface. <macaddr> is a unicast MAC address for that device.
Format
no arp <ipaddress> <macaddr>
Mode Global Config
ip proxy-arp
This command enables proxy ARP on a router interface. Without proxy ARP, a device only
responds to an ARP request if the target IP address is an address configured on the interface where
the ARP request arrived. With proxy ARP, the device may also respond if the target IP address is
reachable. The device only responds if all next hops in its route to the destination are through
interfaces other than the interface that received the ARP request.
Default enabled
Format
ip proxy-arp
Mode Interface Config
no ip proxy-arp
This command disables proxy ARP on a router interface.
Format
no ip proxy-arp
Mode Interface Config
Routing Commands
v1.0, November 2010
4-2