Qos - NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Table 8-33: Protocol-based VLANs Log Messages
Component Message
Protocol Based pbVlanCnfgrInitPhase2Process: Unable to
VLANs
register NIM callback
Protocol Based pbVlanCnfgrInitPhase2Process: Unable to
VLANs
register pbVlan callback with vlans
Protocol Based pbVlanCnfgrInitPhase2Process: Unable to
VLANs
register pbVlan callback with nvStore

QoS

Table 8-34: ACL Log Messages
Component Message
ACL Total number of ACL rules (x) exceeds max
(y) on intf i.
ACL ACL name, rule x: This rule is not being
logged
ACL aclLogTask: error logging ACL rule trap for
correlator number
ACL IP ACL number: Forced truncation of one or
more rules during config migration
Log Messages
Cause
Appears when nimRegisterIntfChange fails
to register pbVlan for link state changes.
Appears when vlanRegisterForChange fails
to register pbVlan for vlan changes.
Appears when nvStoreRegister fails to
register save and restore functions for
configuration save.
Cause
The combination of all ACLs applied to an
interface has resulted in requiring more rules
than the platform supports.
The ACL configuration has resulted in a
requirement for more logging rules than the
platform supports. The specified rule is
functioning normally except for the logging
action.
The system was unable to send an SNMP
trap for this ACL rule which contains a
logging attribute.
While processing the saved configuration,
the system encountered an ACL with more
rules than is supported by the current
version. This may happen when code is
updated to a version supporting fewer rules
per ACL than the previous version.
v1.0, November 2010
8-16