NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 464

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Format
snmp-server {sysname <name> | location <loc> | contact <con>}
Mode Global Config
snmp-server community
This command adds (and names) a new SNMP community. A community <name> is a name
associated with the switch and with a set of SNMP managers that manage it with a specified
privileged level. The length of <name> can be up to 16 case-sensitive characters.
Note: Community names in the SNMP Community Table must be unique. When making
multiple entries using the same community name, the first entry is kept and
processed and all duplicate entries are ignored.
Default • Public and private, which you can rename.
• Default values for the remaining four community names are blank.
Format
snmp-server community <name>
Mode Global Config
no snmp-server community
This command removes this community name from the table. The <name> is the community
name to be deleted.
Format
no snmp-server community <name>
Mode Global Config
snmp-server community ipaddr
This command sets a client IP address for an SNMP community. The address is the associated
community SNMP packet sending address and is used along with the client IP mask value to
denote a range of IP addresses from which SNMP clients may use that community to access the
device. A value of 0.0.0.0 allows access from any IP address. Otherwise, this value is ANDed with
the mask to determine the range of allowed client IP addresses. The name is the applicable
community name.
Default 0.0.0.0
Management Commands
v1.0, November 2010
7-48