NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 497

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
• If you try to configure IPv6 routing without first selecting the dual IPv4-IPv6 routing template,
a warning message appears.
sdm prefer
This command specifies the SDM template to use on the switch.
Default ipv4-routing for IPv4 only builds, dual-ipv4-ipv6 for IPv6 builds
Format
sdm prefer {ipv4-routing {default | data-center} | dual-ipv4-and-ipv6
{default}}
Mode Global Config
Parameter Description
ipv4-routing Supports IPv4 routing only.
-data-center
-default
typically required for a router in the center of a network.
dual-ipv4-and-ipv6 Supports both IPv4 and IPv6 routing.
This option is visible only when the switch supports IPv6 and IPv4 routing.
-default
no sdm prefer
This command returns to the default template.
Format
no sdm prefer
Mode Global Config
show sdm prefer
This command displays SDM template information.
Format
show sdm prefer
Mode User EXEC
To display the resource numbers supported by the active template, use the
privileged EXEC command with no parameters.
Management Commands
: Support more ECMP next hops in IPv4 routes.
: The routing template maximizes system resources for unicast routing,
: Balance IPv4 and IPv6 Layer 2 and Layer 3 functionality.
v1.0, November 2010
show sdm prefer
7-81