NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 421

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
network protocol
This command specifies the network configuration protocol to be used. If you modify this value,
change is effective immediately. If you use the bootp parameter, the switch periodically sends
requests to a BootP server until a response is received. If you use the dhcp parameter, the switch
periodically sends requests to a DHCP server until a response is received. If you use the none
parameter, you must configure the network information for the switch manually.
Default none
Format
network protocol {none | bootp | dhcp}
Mode Privileged EXEC
network mac-address
This command sets locally administered MAC addresses. The following rules apply:
• Bit 6 of byte 0 (called the U/L bit) indicates whether the address is universally administered
(b'0') or locally administered (b'1').
• Bit 7 of byte 0 (called the I/G bit) indicates whether the destination address is an individual
address (b'0') or a group address (b'1').
• The second character, of the twelve character macaddr, must be 2, 6, A or E.
A locally administered address must have bit 6 On (b'1') and bit 7 Off (b'0').
Format
network mac-address <macaddr>
Mode Privileged EXEC
network mac-type
This command specifies whether the switch uses the burned in MAC address or the locally-
administered MAC address.
Default burnedin
Format
network mac-type {local | burnedin}
Mode Privileged EXEC
Management Commands
v1.0, November 2010
7-5