NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 193

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
If a VLAN has IGMP Snooping Querier enabled and IGMP Snooping is operationally disabled on
it, IGMP Snooping Querier functionality is disabled on that VLAN. IGMP Snooping functionality
is re-enabled if IGMP Snooping is operational on the VLAN.
Note: The Querier IP Address assigned for a VLAN takes preference over global
configuration.
The IGMP Snooping Querier application supports sending periodic general queries on the VLAN
to solicit membership reports.
Default disabled
Format
set igmp querier [<vlan-id>] [address ipv4_address]
Mode • Global Config
• VLAN Mode
no set igmp querier
Use this command to disable IGMP Snooping Querier on the system. Use the optional address
parameter to reset the querier address to 0.0.0.0.
Format
no set igmp querier [<vlan-id>] [address]
Mode • Global Config
• VLAN Mode
set igmp querier query-interval
Use this command to set the IGMP Querier Query Interval time. It is the amount of time in
seconds that the switch waits before sending another general query.
Default disabled
Format
set igmp querier query-interval <1-18000>
Mode Global Config
Switching Commands
v1.0, November 2010
3-152