NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 471

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
snmptrap mode
This command activates or deactivates an SNMP trap. Enabled trap receivers are active (able to
receive traps). Disabled trap receivers are inactive (not able to receive traps).
Format
snmptrap mode <name> { <ipaddr | hostname> |<ip6addr |hostname>}
Mode Global Config
no snmptrap mode
This command deactivates an SNMP trap. Disabled trap receivers are unable to receive traps.
Format
no snmptrap mode <name> { <ipaddr | hostname> |<ip6addr |hostname>}
Mode Global Config
snmp trap link-status
This command enables link status traps by interface.
Note: This command is valid only when the Link Up/Down Flag is enabled. See
server enable traps linkmode" on page 7-52
Format
snmp trap link-status
Mode Interface Config
no snmp trap link-status
This command disables link status traps by interface.
Note: This command is valid only when the Link Up/Down Flag is enabled.
Format
no snmp trap link-status
Mode Interface Config
Management Commands
v1.0, November 2010
"snmp-
7-55