NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 309

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Note: An implicit 'deny all' MAC rule always terminates the access list.
A rule may either deny or permit traffic according to the specified classification fields. At a
minimum, the source and destination MAC value must be specified, each of which may be
substituted using the keyword any to indicate a match on any value in that field. The remaining
command parameters are all optional, but the most frequently used parameters appear in the same
relative order as shown in the command format.
The Ethertype may be specified as either a keyword or a four-digit hexadecimal value from
0x0600-0xFFFF. The currently supported <ethertypekey> values are: appletalk, arp, ibmsna,
ipv4, ipv6, ipx, mplsmcast, mplsucast, netbios, novell, pppoe, rarp. Each of these translates into its
equivalent Ethertype value(s).
Ethertype Keyword
appletalk
arp
ibmsna
ipv4
ipv6
ipx
mplsmcast
mplsucast
netbios
novell
pppoe
rarp
The vlan and cos parameters refer to the VLAN identifier and 802.1p user priority fields,
respectively, of the VLAN tag. For packets containing a double VLAN tag, this is the first (or
outer) tag.
Quality of Service (QoS) Commands
Corresponding Value
0x809B
0x0806
0x80D5
0x0800
0x86DD
0x8037
0x8848
0x8847
0x8191
0x8137, 0x8138
0x8863, 0x8864
0x8035
v1.0, November 2010
5-35