NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 367

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
no hardware-address
This command removes the hardware address of the DHCP client.
Format
no hardware-address
Mode DHCP Pool Config
host
This command specifies the IP address and network mask for a manual binding to a DHCP client.
Address and Mask are valid IP addresses; each made up of four decimal bytes ranging from 0 to
255. IP address 0.0.0.0 is invalid. The prefix-length is an integer from 0 to 32.
Default none
Format
host <address> [{<mask> | <prefix-length>}]
Mode DHCP Pool Config
no host
This command removes the IP address of the DHCP client.
Format
no host
Mode DHCP Pool Config
lease
This command configures the duration of the lease for an IP address that is assigned from a DHCP
server to a DHCP client. The overall lease time should be between 1-86400 minutes. If you specify
infinite, the lease is set for 60 days. You can also specify a lease duration. Days is an integer
from 0 to 59. Hours is an integer from 0 to 23. Minutes is an integer from 0 to 59.
Default 1 (day)
Format
lease [{<days> [<hours>] [<minutes>] | infinite}]
Mode DHCP Pool Config
Utility Commands
v1.0, November 2010
6-43