NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 469

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
snmp-server enable traps stpmode
This command enables the sending of new root traps and topology change notification traps.
Default enabled
Format
snmp-server enable traps stpmode
Mode Global Config
no snmp-server enable traps stpmode
This command disables the sending of new root traps and topology change notification traps.
Format
no snmp-server enable traps stpmode
Mode Global Config
snmptrap
This command adds an SNMP trap receiver. The maximum length of <name> is 16 case-sensitive
alphanumeric characters. The <snmpversion> is the version of SNMP. The version parameter
options are snmpv1 or snmpv2. The SNMP trap address can be set using both an IPv4 address
format as well as an IPv6 global address format.
The following shows an example of the CLI command.
(Netgear Switch)# snmptrap mytrap ip6addr 3099::2
Note: The <name> parameter does not need to be unique, however; the <name> and
<ipaddr | hostname> pair must be unique. Multiple entries can exist with the same
<name>, as long as they are associated with a different <ipaddr | hostname>. The
reverse scenario is also acceptable. The <name> is the community name used
when sending the trap to the receiver, but the <name> is not directly associated
with the SNMP Community Table, See "snmp-server community" on page39."
Default snmpv2
Format
snmptrap <name> {ipaddr <ipaddr|hostname> | ip6addr <ip6addr|
hostname>} [snmpversion <snmpversion>]
Mode Global Config
Management Commands
v1.0, November 2010
7-53