NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 281

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
show classofservice dot1p-mapping
This command displays the current Dot1p (802.1p) priority mapping to internal traffic classes for a
specific interface. The <unit/slot/port> parameter is optional and is only valid on
platforms that support independent per-port class of service mappings. If specified, the 802.1p
mapping table of the interface is displayed. If omitted, the most recent global configuration
settings are displayed. For more information, see
Format
show classofservice dot1p-mapping [<unit/slot/port>]
Mode Privileged EXEC
The following information is repeated for each user priority.
Term Definition
User Priority The 802.1p user priority value.
Traffic Class The traffic class internal queue identifier to which the user priority value is mapped.
show classofservice ip-precedence-mapping
This command displays the current IP Precedence mapping to internal traffic classes for a specific
interface. The unit/slot/port parameter is optional and is only valid on platforms that support
independent per-port class of service mappings. If specified, the IP Precedence mapping table of
the interface is displayed. If omitted, the most recent global configuration settings are displayed.
Format
show classofservice ip-precedence-mapping [<unit/slot/port>]
Mode Privileged EXEC
The following information is repeated for each user priority.
Term Definition
IP Precedence The IP Precedence value.
Traffic Class The traffic class internal queue identifier to which the IP Precedence value is mapped.
Quality of Service (QoS) Commands
"Voice VLAN Commands" on page 3-50
v1.0, November 2010
.
5-7