NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 289

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
match cos
This command adds to the specified class definition a match condition for the Class of Service
value (the only tag in a single tagged packet or the first or outer 802.1Q tag of a double VLAN
tagged packet). The value may be from 0 to 7.
Default none
Format
match cos <0-7>
Mode Class-Map Config
Ipv6-Class-Map Config
match ip6flowlbl
This command adds to the specified class definition a match condition based on the IP6flowlbl of
a packet. The label is the value to match in the Flow Label field of the IPv6 header (range 0-
1048575).
Format
match ip6flowlbl <label>
Mode Ipv6-Class-Map Configuration mode
match destination-address mac
This command adds to the specified class definition a match condition based on the destination
MAC address of a packet. The <macaddr> parameter is any layer 2 MAC address formatted as
six, two-digit hexadecimal numbers separated by colons (e.g., 00:11:22:dd:ee:ff). The
<macmask> parameter is a layer 2 MAC address bit mask, which need not be contiguous, and is
formatted as six, two-digit hexadecimal numbers separated by colons (e.g., ff:07:23:ff:fe:dc).
Default none
Format
match destination-address mac <macaddr> <macmask>
Mode Class-Map Config
Ipv6-Class-Map Config
Quality of Service (QoS) Commands
v1.0, November 2010
5-15