NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 124

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Default enabled
Format
storm-control broadcast
Mode Interface Config
no storm-control broadcast
Use this command to disable broadcast storm recovery mode for a specific interface.
Format
no storm-control broadcast
Mode Interface Config
storm-control broadcast level
Use this command to configure the broadcast storm recovery threshold for an interface as a
percentage of link speed and enable broadcast storm recovery. If the mode is enabled, broadcast
storm recovery is active, and if the rate of L2 broadcast traffic ingressing on an interface increases
beyond the configured threshold, the traffic is dropped. Therefore, the rate of broadcast traffic is
limited to the configured threshold.
Default 5
Format
storm-control broadcast level <0-100>
Mode Interface Config
no storm-control broadcast level
This command sets the broadcast storm recovery threshold to the default value for an interface and
disables broadcast storm recovery.
Format
no storm-control broadcast level
Mode Interface Config
Switching Commands
v1.0, November 2010
3-83