NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 274

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
no ip icmp echo-reply
Use this command to prevent the generation of ICMP Echo Reply messages by the router.
Format
no ip icmp echo-reply
Mode Global Config
ip icmp error-interval
Use this command to limit the rate at which IPv4 ICMP error messages are sent. The rate limit is
configured as a token bucket, with two configurable parameters, burst-size and burst-interval.
The burst-interval specifies how often the token bucket is initialized with burst-size tokens. burst-
interval is from 0 to 2147483647 milliseconds (msec).
The burst-size is the number of ICMP error messages that can be sent during one burst-interval.
The range is from 1 to 200 messages.
To disable ICMP rate limiting, set burst-interval to zero (0).
Default • burst-interval of 1000 msec.
• burst-size of 100 messages
Format ip icmp error-interval <burst-interval> [<burst-size>]
Mode Global Config
no ip icmp error-interval
Use the no form of the command to return burst-interval and burst-size to their default values.
Format
no ip icmp error-interval
Mode Global Config
Routing Commands
v1.0, November 2010
4-28