NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 131

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Default disabled
Format
storm-control unicast
Mode Interface Config
no storm-control unicast
This command disables unicast storm recovery mode for an interface.
Format
no storm-control unicast
Mode Interface Config
storm-control unicast level
This command configures the unicast storm recovery threshold for an interface as a percentage of
link speed, and enables unicast storm recovery. If the mode is enabled, unicast storm recovery is
active, and if the rate of unknown L2 unicast (destination lookup failure) traffic ingressing on an
interface increases beyond the configured threshold, the traffic will be dropped. Therefore, the rate
of unknown unicast traffic will be limited to the configured threshold.This command also enables
unicast storm recovery mode for an interface.
Default 5
Format
storm-control unicast level <0-100>
Mode Interface Config
no storm-control unicast level
This command sets the unicast storm recovery threshold to the default value for an interface and
disables unicast storm recovery.
Format
no storm-control unicast level
Mode Interface Config
Switching Commands
v1.0, November 2010
3-90