NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 133

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Format
no storm-control unicast
Mode Global Config
storm-control unicast level (Global)
This command configures the unicast storm recovery threshold for all interfaces as a percentage of
link speed, and enables unicast storm recovery. If the mode is enabled, unicast storm recovery is
active, and if the rate of unknown L2 unicast (destination lookup failure) traffic ingressing on an
interface increases beyond the configured threshold, the traffic will be dropped. Therefore, the rate
of unknown unicast traffic will be limited to the configured threshold.
Default 5
Format
storm-control unicast level <0-100>
Mode Global Config
no storm-control unicast level
This command sets the unicast storm recovery threshold to the default value and disables unicast
storm recovery for all interfaces.
Format
no storm-control unicast level
Mode Global Config
storm-control unicast rate (Global)
Use this command to configure the unicast storm recovery threshold for all interfaces in packets
per second. If the mode is enabled, unicast storm recovery is active, and if the rate of L2 broadcast
traffic ingressing on an interface increases beyond the configured threshold, the traffic is dropped.
Therefore, the rate of unicast traffic is limited to the configured threshold.
Default 0
Format
storm-control unicast rate <0-14880000>
Mode Global Config
Switching Commands
v1.0, November 2010
3-92