NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 252

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
clear arp-switch
Use this command to clear the contents of the switch's Address Resolution Protocol (ARP) table
that contains entries learned through the Management port. To observe whether this command is
successful, ping from the remote system to the DUT. Issue the show arp switch command
to see the ARP entries. Then issue the clear arp-switch command and check the show
arp switch entries. There will be no more arp entries.
Format
clear arp-switch
Mode Privileged EXEC
show arp
This command displays the Address Resolution Protocol (ARP) cache. The displayed results are
not the total ARP entries. To view the total ARP entries, the operator should view the show arp
results in conjunction with the show arp switch results.
Format
show arp
Mode Privileged EXEC
Term Definition
Age Time The time it takes for an ARP entry to age out. This is configurable. Age time is measured
(seconds)
in seconds.
Response Time The time it takes for an ARP request timeout. This value is configurable. Response time
(seconds)
is measured in seconds.
Retries The maximum number of times an ARP request is retried. This value is configurable.
Cache Size The maximum number of entries in the ARP table. This value is configurable.
Dynamic Renew Displays whether the ARP component automatically attempts to renew dynamic ARP
Mode
entries when they age out.
Total Entry Count The total entries in the ARP table and the peak entry count in the ARP table.
Current / Peak
Static Entry Count The static entry count in the ARP table, the active entry count in the ARP table, the
Configured/Active
active entry count in the ARP table, and maximum static entry count in the ARP table.
/ Max
The following are displayed for each ARP entry:
Term Definition
IP Address The IP address of a device on a subnet attached to an existing routing interface.
Routing Commands
v1.0, November 2010
4-6