Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-
Max Int
Min Int
Hold Time
Preference
14.4 Virtual LAN Routing Commands
This section describes the commands you use to view and configure VLAN routing and to
view VLAN routing status information.
14.4.1 vlan routing
This command creates routing on a VLAN. The
4094.
Format
Mode
14.4.1.1 no vlan routing
This command deletes routing on a VLAN. The
4094.
Format
Mode
14.4.2 show ip vlan
This command displays the VLAN routing information for all VLANs with routing
enabled.
Format
Modes
14-22
Displays the maximum advertise interval, which is the maxi-
mum time, in seconds, allowed between sending router
advertisements from the interface.
Displays the minimum advertise interval, which is the mini-
mum time, in seconds, allowed between sending router
advertisements from the interface.
Displays the amount of time, in seconds, that a system should
keep the router advertisement before discarding it.
Displays the preference of the address as a default router
address, relative to other router addresses on the same subnet.
<vlanid>
vlan routing <vlanid>
VLAN Config
<vlanid>
no vlan routing <vlanid>
VLAN Config
show ip vlan
Privileged EXEC
User EXEC
v1.0, December 2005
value has a range from 1 to
value has a range from 1 to
Routing Commands