NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 111

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Format
no dot1x port-control all
Mode Global Config
dot1x re-authenticate
This command begins the re-authentication sequence on the specified port. This command is only
valid if the control mode for the specified port is "auto" or "mac-based". If the control mode is not
"auto" or "mac-based", an error will be returned.
Format
dot1x re-authenticate <unit/slot/port>
Mode Privileged EXEC
dot1x re-authentication
This command enables re-authentication of the supplicant for the specified port.
Default disabled
Format
dot1x re-authentication
Mode Interface Config
no dot1x re-authentication
This command disables re-authentication of the supplicant for the specified port.
Format
no dot1x re-authentication
Mode Interface Config
dot1x system-auth-control
Use this command to enable the dot1x authentication support on the switch. While disabled, the
dot1x configuration is retained and can be changed, but is not activated.
Switching Commands
v1.0, November 2010
3-70