NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 327

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
boot autoinstall auto-save
This command is used to enable automatically saving the downloaded configuration on the switch.
.
Default Disabled
Format
boot autoinstall auto-save
Mode Privileged EXEC
no boot autoinstall auto-save
This command is used to disable automatically saving the downloaded configuration on the
switch.
Format
no boot autoinstall auto-save
Mode Privileged EXEC
boot autoinstall start
The command is used to start Auto Install on the switch. Auto Install tries to download a config
file from a TFTP server.
Format
boot autoinstall start
Mode Privileged EXEC
boot autoinstall stop
The command is used to A user may terminate the Auto Install process at any time prior to the
downloading of the config file. This is most optimally done when the switch is disconnected from
the network, or if the requisite configuration files have not been configured on TFTP servers.
Termination of the Auto Install process ends further periodic requests for a host-specific file.
Format
boot autoinstall stop
Mode Privileged EXEC
Utility Commands
v1.0, November 2010
6-3