NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 308

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
If a MAC ACL by this name already exists, this command enters Mac-Access-List config mode to
allow updating the existing MAC ACL.
Note: The CLI mode changes to Mac-Access-List Config mode when you successfully
execute this command.
Format
mac access-list extended <name>
Mode Global Config
no mac access-list extended
This command deletes a MAC ACL identified by <name> from the system.
Format
no mac access-list extended <name>
Mode Global Config
mac access-list extended rename
This command changes the name of a MAC Access Control List (ACL). The <name> parameter
is the name of an existing MAC ACL. The <newname> parameter is a case-sensitive
alphanumeric string from 1 to 31 characters uniquely identifying the MAC access list.
This command fails if a MAC ACL by the name <newname> already exists.
Format
mac access-list extended rename <name> <newname>
Mode Global Config
{deny | permit} (MAC ACL)
This command creates a new rule for the current MAC access list. Each rule is appended to the list
of configured rules for the list.
Note: The 'no' form of this command is not supported, since the rules within a MAC ACL
cannot be deleted individually. Rather, the entire MAC ACL must be deleted and
re-specified.
Quality of Service (QoS) Commands
v1.0, November 2010
5-34