NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 132

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
storm-control unicast rate
Use this command to configure the unicast storm recovery threshold for an interface in packets per
second. If the mode is enabled, unicast storm recovery is active, and if the rate of L2 broadcast
traffic ingressing on an interface increases beyond the configured threshold, the traffic is dropped.
Therefore, the rate of unicast traffic is limited to the configured threshold.
Default 0
Format
storm-control unicast rate <0-14880000>
Mode Interface Config
no storm-control unicast rate
This command sets the unicast storm recovery threshold to the default value for an interface and
disables unicast storm recovery.
Format
no storm-control unicast rate
Mode Interface Config
storm-control unicast (Global)
This command enables unicast storm recovery mode for all interfaces. If the mode is enabled,
unicast storm recovery is active, and if the rate of unknown L2 unicast (destination lookup failure)
traffic ingressing on an interface increases beyond the configured threshold, the traffic will be
dropped. Therefore, the rate of unknown unicast traffic will be limited to the configured threshold.
Default disabled
Format
storm-control unicast
Mode Global Config
no storm-control unicast
This command disables unicast storm recovery mode for all interfaces.
Switching Commands
v1.0, November 2010
3-91