NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 19

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Table 5. CLI Command Modes (continued)
Command Mode Prompt
TACACS Config Switch (Tacacs)#
DHCP Pool Switch (Config dhcp-pool)#
Config
DHCPv6 Pool Switch (Config dhcp6-pool)#
Config
Stack Global Switch (Config stack)#
Config Mode
ARP Access-List Switch (Config-arp-access-list)#
Config Mode
Table 6 explains how to enter or exit each mode.
Table 6. CLI Mode Access and Exit
Command Mode Access Method
User EXEC This is the first level of access.
Privileged EXEC From the User EXEC mode, enter
enable.
Global Config From the Privileged EXEC mode,
enter configure.
VLAN Config From the Privileged EXEC mode,
enter vlan database.
Interface Config From the Global Config mode,
enter
interface <unit/slot/port>
or interface loopback <id>
or interface tunnel <id>
Line Config From the Global Config mode,
enter
lineconfig.
Policy-Map From the Global Config mode,
Config enter
policy-map <name> in.
Policy-Class-Map From the Policy Map mode enter
Config
class.
Using the Command-Line Interface
Mode Description
Contains commands to configure properties for
the TACACS servers.
Contains the DHCP server IP address pool
configuration commands.
Contains the DHCPv6 server IPv6 address pool
configuration commands.
Allows you to access the Stack Global Config
Mode.
Contains commands to add ARP ACL rules in
an ARP Access List.
Exit or Access Previous Mode
To exit, enter logout.
To exit to the User EXEC mode, enter exit or
press Ctrl-Z.
To exit to the Privileged EXEC mode, enter exit,
or press Ctrl-Z.
To exit to the Privileged EXEC mode, enter exit,
or press Ctrl-Z.
To exit to the Global Config mode, enter exit. To
return to the Privileged EXEC mode, enter Ctrl-
Z.
To exit to the Global Config mode, enter exit. To
return to the Privileged EXEC mode, enter Ctrl-
Z.
To exit to the Global Config mode, enter exit. To
return to the Privileged EXEC mode, enter Ctrl-
Z.
To exit to the Policy Map mode, enter exit. To
return to the Privileged EXEC mode, enter Ctrl-
Z.
v1.0, November 2010
1-7