Front Panel Stacking Commands - NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
If you do not supply a value for <switchindex>, the following output appears:
Term Definition
Switch Index (SID) The index into the database of supported switch types. This index is used when
preconfiguring a member to be added to the stack.
Model Identifier The model identifier for the supported switch type.
Management The management preference value of the switch type.
Preference
Code Version The code load target identifier of the switch type.
If you supply a value for <switchindex>, the following output appears:
Term Definition
Switch Type The 32-bit numeric switch type for the supported switch.
Model Identifier The model identifier for the supported switch type.
Switch The description for the supported switch type.
Description

Front Panel Stacking Commands

This section describes the commands you use to view and configure front panel stacking
information.
stack-port
This command sets front panel stacking per port to either stack or ethernet mode.
Default stack
Format
stack-port <unit/slot/port> [{ethernet | stack}]
Mode Stack Global Config
Stacking Commands
v1.0, November 2010
2-10