NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 344

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
no logging console
This command disables logging to the console.
Format
no logging console
Mode Global Config
logging host
This command enables logging to a host. You can configure up to eight hosts. The
<ipaddr|hostname> is the IP address of the logging host. The <addresstype> indicates
the type of address ipv4 or ipv6 or dns being passed. The <port> value is a port number from 1
to 65535. You can specify the <severitylevel> value as either an integer from 0 to 7 or
symbolically through one of the following keywords: emergency (0), alert (1), critical
(2), error (3), warning (4), notice (5), info (6), or debug (7).
Default • port—514
• level—critical (2)
Format
logging host <ipaddr|hostname> <addresstype>
[<port>][<severitylevel>]
Mode Global Config
logging host remove
This command disables logging to host. See
indexes.
Format
logging host remove <hostindex>
Mode Global Config
logging syslog
This command enables syslog logging. The <portid> parameter is an integer with a range of 1-
65535.
Default disabled
Format
logging syslog [port <portid>]
Mode Global Config
Utility Commands
"show logging hosts" on page 6-22
v1.0, November 2010
for a list of host
6-20