Show Captive-Portal Configuration Interface - NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Format
show captive-portal configuration <1-10>
Mode Privileged EXEC mode
Term Definition
CP ID The captive portal ID
CP Name The captive portal instance name
Operational Status The operational status is enabled or disabled.
Disable Reason If the operational status is disabled, this field shows the reason.
Blocked Status Blocked status shows if this captive portal instance block all traffic.
Authenticated The authenticated users by this captive portal instance.
Users
Example
(switch)#show captive-portal configuration 1
CP ID..................................... 1
CP Name................................... cp1
Operational Status........................ Disabled
Disable Reason............................ Administrator Disabled
Blocked Status............................ Not Blocked
Authenticated Users....................... 0

show captive-portal configuration interface

Use this command to display information about all interfaces assigned to a captive portal
configuration or about a specific interface assigned to a captive portal configuration. The <1-10>
is the captive portal ID. If you do not specify an interface number, all the interfaces assigned to the
captive portal configuration will be displayed.
Format
show captive-portal configuration <1-10> interface [ <unit/slot/
port> ]
Mode Privileged EXEC mode
Captive Portal Commands
v1.0, November 2010
9-15