NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 288

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
match class-map
This command adds to the specified class definition the set of match conditions defined for another
class. The <refclassname> is the name of an existing DiffServ class whose match conditions
are being referenced by the specified class definition.
Default
none
Format
match class-map <refclassname>
Mode Class-Map Config
Ipv6-Class-Map Config
Note:
• The parameters <refclassname> and <class-map-name> can not be the same.
• Only one other class may be referenced by a class.
• Any attempts to delete the <refclassname> class while the class is still referenced by any <class-
map-name> fails.
• The combined match criteria of <class-map-name> and <refclassname> must be an allowed
combination based on the class type.
• Any subsequent changes to the <refclassname> class match criteria must maintain this validity, or
the change attempt fails.
• The total number of class rules formed by the complete reference class chain (including both
predecessor and successor classes) must not exceed a platform-specific maximum. In some
cases, each removal of a refclass rule reduces the maximum number of available rules in the
class definition by one.
no match class-map
This command removes from the specified class definition the set of match conditions defined for
another class. The <refclassname> is the name of an existing DiffServ class whose match
conditions are being referenced by the specified class definition.
Format
no match class-map <refclassname>
Mode Class-Map Config
Ipv6-Class-Map Config
Quality of Service (QoS) Commands
v1.0, November 2010
5-14