NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 151

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
no port-channel linktrap
This command disables link trap notifications for the port-channel (LAG). The interface is a
logical slot and port for a configured port-channel. The option all disables link trap notifications
for all the configured port-channels.
Format
no port-channel linktrap {<logical unit/slot/port> | all}
Mode Global Config
port-channel load-balance
This command selects the load-balancing option used on a port-channel (LAG). Traffic is balanced
on a port-channel (LAG) by selecting one of the links in the channel over which to transmit
specific packets. The link is selected by creating a binary pattern from selected fields in a packet,
and associating that pattern with a particular link.
Load-balancing is not supported on every device. The range of options for load-balancing may
vary per device. The XSM7224S also supports enhanced hashing mode, which has the following
advantages:
• MODULO-N (where N is the number of active link members in a LAG) operation based on
the number of ports in the LAG
• Packet attributes selection based on the packet type: For L2 packets, source and destination
MAC address are used for hash computation. For L3 packets, source IP, destination IP address,
TCP/UDP ports are used.
• Non-Unicast traffic and unicast traffic is hashed using a common hash algorithm
• Excellent load balancing performance
.
Default 3
Format
port-channel load-balance { 1 | 2 | 3 | 4 | 5 | 6 | 7} {<unit/slot/
port> |<all>}
Mode Interface Config
Global Config
Term Definition
1 Source MAC, VLAN, EtherType, and incoming port associated with the packet
2 Destination MAC, VLAN, EtherType, and incoming port associated with the packet
Switching Commands
v1.0, November 2010
3-110