Static Mac Filtering - NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0

Static MAC Filtering

The commands in this section describe how to configure static MAC filtering. Static MAC
filtering allows you to configure destination ports for a static multicast MAC filter irrespective of
the platform.
macfilter
This command adds a static MAC filter entry for the MAC address <macaddr> on the VLAN
<vlanid>. The value of the <macaddr> parameter is a 6-byte hexadecimal number in the
format of b1:b2:b3:b4:b5:b6. The restricted MAC Addresses are: 00:00:00:00:00:00,
01:80:C2:00:00:00 to 01:80:C2:00:00:0F, 01:80:C2:00:00:20 to 01:80:C2:00:00:21, and
FF:FF:FF:FF:FF:FF. The <vlanid> parameter must identify a valid VLAN.
The number of static mac filters supported on the system is different for MAC filters where source
ports are configured and MAC filters where destination ports are configured.
• For unicast MAC address filters and multicast MAC address filters with source port lists, the
maximum number of static MAC filters supported is 20.
• For multicast MAC address filters with destination ports configured, the maximum number of
static filters supported is 256.
i.e. For current platforms, you can configure the following combinations:
• Unicast MAC and source port (max = 20)
• Multicast MAC and source port (max=20)
• Multicast MAC and destination port (only) (max=256)
• Multicast MAC and source ports and destination ports (max=20)
Format
macfilter <macaddr> <vlanid>
Mode Global Config
no macfilter
This command removes all filtering restrictions and the static MAC filter entry for the MAC
address <macaddr> on the VLAN <vlanid>. The <macaddr> parameter must be specified
as a 6-byte hexadecimal number in the format of b1:b2:b3:b4:b5:b6.
Switching Commands
v1.0, November 2010
3-118