Differences From Lockout Configuration For Pppoe Over Static Atm; Configuration Tasks; Configuring And Verifying Lockout For Pppoe Clients; Table 29: Differences In Lockout Operation For Dynamic Pppoe - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual

Software for e series broadband services routers link layer configuration guide
Table of Contents

Advertisement

Copyright © 2010, Juniper Networks, Inc.
For information about the working of the dynamic encapsulation type lockout feature
for PPPoE sessions that contain the IWF-Session DSL Forum VSA (26-254) in PADR
packets, see "Encapsulation Type Lockout Based on DSL Forum VSAs for IWF PPPoE
Sessions" on page 523.
For illustrations of the interface stacking in dynamic PPPoE over static PPPoE
configurations, see Figure 49 on page 531, Figure 50 on page 533, Figure 51 on page 534, and
Figure 53 on page 539.

Differences from Lockout Configuration for PPPoE over Static ATM

Table 29 on page 545 lists the important differences between how encapsulation type
lockout works for dynamic PPPoE over static PPPoE configurations and how lockout
works for dynamic PPPoE over static ATM 1483 configurations.

Table 29: Differences in Lockout Operation for Dynamic PPPoE

Configurations
Dynamic PPPoE over Static PPPoE
Encapsulation type lockout is disabled by
default.
You must explicitly configure encapsulation
type lockout for PPPoE clients with the
pppoe auto-configure command.
For more information about the benefits and operation of dynamic encapsulation type
lockout, see "Encapsulation Type Lockout" on page 521. In particular, see "Guidelines for
Configuring Encapsulation Type Lockout for PPPoE sessions" on page 523 for information
about the rules that apply when you configure the lockout time. These rules are common
to both dynamic PPPoE over static PPPoE configurations and dynamic PPPoE over static
ATM 1483 configurations.

Configuration Tasks

Configuring dynamic encapsulation type lockout for PPPoE clients includes the following
tasks:

Configuring and verifying lockout for PPPoE clients

Clearing the lockout condition for a specific PPPoE client
Configuring and Verifying Lockout for PPPoE Clients
To configure and verify encapsulation type lockout for a PPPoE client:
Chapter 17: Configuring Dynamic Interfaces
Dynamic PPPoE over Static ATM 1483
Encapsulation type lockout is enabled by default
with a lockout time range of 1–300 seconds.
PPPoE clients automatically inherit their lockout
setting from the lockout parameters configured
for the underlying static ATM 1483 subinterface
with the auto-configure command.
Currently, the dynamic PPPoE interface layer must
be configured directly above the static ATM 1483
interface layer to support inheritance of lockout
parameters. For an illustration of dynamic PPPoE
over static ATM 1483 interface stacking, see Figure
48 on page 526.
545

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose 11.3

Table of Contents