Table of Contents
Advertisement
JUNOSe 11.1.x Physical Layer Configuration Guide
2.
NOTE: When you issue the tunnel-server command, ensure that you specify the
same interface specifier that was displayed for this tunnel-server port in the show
tunnel-server config command in the output described in "Identifying the Physical
Location of the Tunnel-Server Port" on page 225. If you specify an incorrect location
for the tunnel-server port, the router displays an error message and rejects the
command as invalid.
Verifying the Tunnel-Server Interface Configuration
To verify that you properly provisioned the number of tunnel-server interfaces on
the tunnel-server port:
1.
2.
Unprovisioning Tunnel-Service Interfaces
To unprovision the tunnel-service interfaces on a tunnel-server port, use any of the
following commands, all of which have the same effect:
226
Configuring Tunnel-Server Ports and Tunnel-Service Interfaces
Provision the maximum number of tunnel-service interfaces to be used on the
dedicated tunnel-server port.
host1(config-tunnel-server)#max-interfaces all-available
From Tunnel Server Configuration Mode, return to Privileged Exec mode.
host1(config-tunnel-server)#exit
host1(config)#exit
host1#
Issue the show tunnel-server config command.
host1#show tunnel-server config
Port
Type
--------
-------
Port 2/2
shared
Port 8/0
dedicated
For more information about using the show tunnel-server command, see
"Monitoring Tunnel-Service Interfaces" on page 228.
Issue the no max-interfaces command from Tunnel Server Configuration mode.
host1(config-tunnel-server)#no max-interfaces
Issue the max-interfaces 0 command from Tunnel Server Configuration mode.
host1(config-tunnel-server)#max-interfaces 0
Server Ports
------------
Provisioned
MaximumInterfaces
Interfaces
-----------------
-----------
8000
5000
16000
all-available yes
HwPresent
---------
yes
Advertisement
Table of Contents
