Verifying Virtual Chassis Configuration - Juniper JUNOS OS 10.3 - SOFTWARE Manual

CHAPTER 46

Verifying Virtual Chassis Configuration

Command Forwarding Usage with a Virtual Chassis Configuration
Copyright © 2010, Juniper Networks, Inc.
Command Forwarding Usage with a Virtual Chassis Configuration on page 1035
Verifying the Member ID, Role, and Neighbor Member Connections of a Virtual Chassis
Member on page 1038
Verifying That the Virtual Chassis Ports Are Operational on page 1040
Monitoring Virtual Chassis Configuration Status and Statistics on page 1041
Replacing a Member Switch of a Virtual Chassis Configuration (CLI
Procedure) on page 1042
Verifying That Graceful Routing Engine Switchover Is Working in the Virtual Chassis
Configuration on page 1044
Some CLI commands can be run either on all members or on a specific member of a
Virtual Chassis configuration. This functionality is referred to as command forwarding.
For example, to collect information about your system prior to contacting Juniper Networks
Technical Assistance Center (JTAC), use the command
all-members to gather data for all the member switches. If you want to gather this data
only for a particular member switch, use the command
.
member member-id
Table 151 on page 1036 provides a list of commands that can be run either on all members
of the Virtual Chassis configuration or on a specific member switch.
request support information
request support information
1035