Configuration Tasks; Configuring And Verifying Lockout For Pppoe Clients - Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual

Table 23: Differences in Lockout Operation for Dynamic PPPoE Configurations
Dynamic PPPoE over Static PPPoE
Encapsulation type lockout is disabled by
default.
You must explicitly configure encapsulation
type lockout for PPPoE clients with the
pppoe auto-configure command.
For more information about the benefits and operation of dynamic encapsulation
type lockout, see "Encapsulation Type Lockout" on page 475. In particular, see
"Guidelines for Configuring Encapsulation Type Lockout" on page 477 for information
about the rules that apply when you configure the lockout time. These rules are
common to both dynamic PPPoE over static PPPoE configurations and dynamic
PPPoE over static ATM 1483 configurations.

Configuration Tasks

Configuring dynamic encapsulation type lockout for PPPoE clients includes the
following tasks:

Configuring and verifying lockout for PPPoE clients

Clearing the lockout condition for a specific PPPoE client
Configuring and Verifying Lockout for PPPoE Clients
To configure and verify encapsulation type lockout for a PPPoE client:
Configure the underlying physical interface.
1.
For example, the following commands configure a static ATM 1483 subinterface
and corresponding ATM PVC.
host1(config)#interface atm 3/0
host1(config-if)#interface atm 3/0.101
host1(config-subif)#atm pvc 10 10 20 aal5snap
Create a static PPPoE major interface.
2.
host1(config-subif)#encapsulation pppoe
Configure the PPPoE major interface to detect and accept dynamic PPPoE
3.
subinterfaces. Use the lockout-time keyword to configure a nondefault lockout
Configuring PPPoE Dynamic Interfaces over PPPoE Static Interfaces
Chapter 15: Configuring Dynamic Interfaces
Dynamic PPPoE over Static ATM 1483
Encapsulation type lockout is enabled by default
with a lockout time range of 1–300 seconds.
PPPoE clients automatically inherit their lockout
setting from the lockout parameters configured
for the underlying static ATM 1483 subinterface
with the auto-configure command.
Currently, the dynamic PPPoE interface layer must
be configured directly above the static ATM 1483
interface layer to support inheritance of lockout
parameters. For an illustration of dynamic PPPoE
over static ATM 1483 interface stacking, see Figure
42 on page 479.
499