Installation And Connection; Installation; Installing Rack - NEC N8100-2836F User Manual

Chapter 2 Preparations
2.

Installation and Connection

This section describes how to install the server and connect cables.
2.1

Installation

This server must be mounted to a rack which conforms to EIA standards for use.

Installing Rack

Refer to the manual that comes with your rack for how to install the rack, or consult with your sales representative.
Be sure to observe the following precautions to use the server safety. Failure to observe the
precautions may cause death or serious injury. For details, refer to Safety Precautions and
Regulatory Notices.


Be sure to observe the following precautions to use the server safely. Failure to observe the
precautions may cause burns, injury, and property damage. For details, refer to Safety Precautions
and Regulatory Notices.







WARNING
Use only in the specified environment.
Do not connect the ground wire to a gas pipe.
Do not carry or install the server only by a single person.
Do not install the server so that the load may be concentrated on a specific point.
Do not install any components only by a single person.
Confirm that hinge pins of the door are completely secured in place.
Do not pull out the server from the rack when the rack is unstable.
Do not leave more than one device being pulled out from the rack.
Do not provide the wiring for the server to exceed the rating of the power supply.
Do not use the server in the environment where corrosive gas is generated.
Express5800/R120h-2M (3rd-Gen) User's Guide
CAUTION
2. Installation and Connection
203