NEC NEAX 2000 Programming Manual page 996

(1/2)
MAINTENANCE ADMINISTRATION TERMINAL (MAT)
GENERAL DESCRIPTION
The MAINTENANCE ADMINISTRATION TERMINAL (MAT) is a Personal Computer (PC) used
for programming and maintenance of the system. The MAT can provide a fault message output. Addition-
ally, the MAT can be used to REMOVE AND RESTORE SERVICE any station in the system and can read
or save system data from disks.
STATION APPLICATION
Not applicable
OPERATING PROCEDURE
Refer to the Command Manual and MATWorX User's Guide.
SERVICE CONDITIONS
®
1. Any IBM or compatible PC can be used as a MAT.
Note: IBM is a registered trade mark of International Business Machine.
2. Connection through modems is available, providing remote maintenance capabilities.
3. The MAT can be connected to the system either directly or remotely. Remote connection is available
via either an internal modem on the MP card or an external modem. Remote connection via the inter-
nal modem is through the COT card. Connection between the modem and the COT is accomplished
through internal switching of the TDSW. Remote connection via an external modem is through the
MP card.
4. The following functions can be performed from the MAT:
a. System, station, and trunk data entry, change, and copy.
b. Loading, saving, and verification of system data to and from a disk.
c. ROM check readout of generic program.
d. Display of fault/fault cleared messages.
e. On site or remote access to the system.
f. Printout of system data (when printer is connected to PC).
g. Display and setting of system clock/calendar.
h. Call Pickup / Station Hunting / UCD - Group
i. Least Cost Routing (LCR)
j. Numbering Plan
k. System Initialize
5. The PC used as the MAT must have an RS-232C port, and cannot be located more than 15 m from the
system when connected on premises.
Page 214
Revision 1.0
ND-91285-001(E)
DECEMBER, 1999