Camshaft Inspection - Honda Accord 2008 Manual

07/11/02 09:25:43 61TA0000_060_0088
Cylinder Head

Camshaft Inspection

NOTE: Do not rotate the camshaft during inspection.
1. Remove the rocker arm assembly (see page 6-84).
2. Put the rocker shaft holders, camshaft, and
camshaft holders on the cylinder head, then tighten
the bolts, in sequence, to the specified torque.
NOTE: If the engine does not have bolt
and continue the torque sequence.
Specified Torque
8 x 1.25 mm
22 N·m (2.2 kgf·m, 16 lbf·ft)
6 x 1.0 mm
12 N·m (1.2 kgf·m, 8.7 lbf·ft)
6 x 1.0 mm Bolts:
＊０１
6-88
, skip it
, ,
3. Seat the camshaft by pushing it away from the
camshaft pulley end of the cylinder head.
4. Zero the dial indicator against the end of the
camshaft, then push the camshaft back and forth,
and read the end play. If the end play is beyond the
service limit, replace the cylinder head and recheck.
If it is still beyond the service limit, replace the
camshaft.
Camshaft End Play
Standard (New): 0.05 0.20 mm −
(0.002 0.008 in.) −
Service Limit: 0.4 mm (0.02 in.)
ＴＡ０８ＡＥＪＡ１４６１６７０００００ＭＡＡＴ００
＊０２