Honda Accord 2008 Manual page 216

07/11/02 09:25:47 61TA0000_060_0093
9. Apply a thin coat of new engine oil to the outside of
the new valve guide. Install the guide from the
camshaft side of the head; use the 5.5 mm valve
guide driver to drive the guide in to the specified
installed height (A) of the guide (B). If you have all
16 guides to do, you may have to reheat the head.
Valve Guide Installed Height
Intake:
Exhaust: 15.5 16.5 mm (0.610 0.650 in.)
＊０５
− −
15.2 16.2 mm (0.598 0.638 in.)
− −
07742-0010100
B
A
10. Coat both the reamer and the valve guide with
cutting oil.
11. Rotate the reamer clockwise to the full length of the
valve guide bore.
07HAH-PJ7A100
12. Continue to rotate the reamer clockwise while
removing it from the bore.
13. Thoroughly wash the guide in detergent and water
to remove any cutting residue.
14. Check the clearances with a valve (see page 6-91).
Verify that a valve slides into the intake and
exhaust valve guides without sticking.
＊０６
6-93