Rocker Arm And Shaft Disassembly/Reassembly - Honda Accord 2008 Manual

07/11/02 09:25:42 61TA0000_060_0085

Rocker Arm and Shaft Disassembly/Reassembly

NOTE:
• Identify each part as it is removed so that each item can be reinstalled in its original position.
• Inspect the rocker arm shaft and rocker arms (see page 6-86).
• If reused, the rocker arms must be installed in the same positions.
• When removing, or installing the rocker arm assembly, do not remove the camshaft holder bolts. The bolts will keep
the holders and rocker arms on the shaft.
• Prior to reassembling, clean all the parts in solvent, dry them, and apply lubricant to any contact points.
• Bundle the rocker arms with rubber bands to keep them together as a set.
• When replacing the VTEC rocker arm assembly, remove the fastening hardware from the new VTEC rocker arm
assembly.
＊０１
RUBBER BAND
No. 1
ROCKER
SHAFT HOLDER
ＴＡ０８ＡＥＪＡ１４６６６３５１５１１ＭＦＡＴ００
No. 3
No. 2
ROCKER SHAFT ROCKER SHAFT
HOLDER HOLDER
EXHAUST ROCKER
SHAFT
EXHAUST ROCKER ARM
ASSEMBLY
No. 5
ROCKER
SHAFT HOLDER
RUBBER BAND
No. 4 INTAKE ROCKER
ARM ASSEMBLY
ROCKER SHAFT
HOLDER
INTAKE ROCKER SHAFT
6-85