05F Damaged Documents RAP
Use this RAP if the documents get damaged by the DADH.
Procedure
Perform the steps that follow :
1.
If the DADH damages the bottom of the documents mid-way along the lead edge, install a
new feed roll assembly, PL 5.15 Item 1.
2.
ADJ 5.2 DADH height adjustment.
3.
Check the input tray for damage, PL 5.35 Item 1.
•
Make sure that the document width guides move freely.
•
Check that the takeaway roll assembly and exit roll assembly, PL 5.35 Item 6 for
damage and contamination, refer to ADJ 5.4.
•
Check the restack arm for damage, PL 5.35 Item 3.
4.
Open the DADH top access cover assembly, PL 5.20 Item 17.
•
Check the document path for damage.
•
Check the takeaway roll idlers and CVT roll idlers, PL 5.20 Item 3 for damage. Make
sure the idlers are clean and rotate freely, refer to ADJ 5.4.
5.
Raise the DADH. Lower the baffle assembly, Figure 1.
•
Remove any pieces of paper.
•
Check the duplex gate, PL 5.25 Item 12 for damage. Make sure the duplex gate
moves freely.
•
Check the CVT roll, PL 5.25 Item 5 for damage. If necessary, clean the CVT roll,
ADJ 5.4.
•
Check the pre-scan idlers, PL 5.25 Item 6 and post scan idlers, PL 5.30 Item 6 for
damage. Make sure the idlers are clean and rotate freely, refer to ADJ 5.4.
•
Check the document path for damage.
•
Check the baffle assembly, PL 5.30 Item 5 for damage.
•
Check the exit roll idlers for damage, PL 5.30 Item 8. Make sure the idlers are clean
and rotate freely, ADJ 5.4.
6.
Check the CVT ramp assembly, (32-55 ppm) PL 14.20 Item 13 or (65-87 ppm) PL 14.10
Item 13 for damage.
7.
Make sure that the customers documents are within the specification, refer to GP 20.
Status Indicator RAPs
05F
Pre-scan idlers
Figure 1 Component location
August 2007
2-132
Baffle assembly
Duplex gate
CVT roll
Post scan idlers
WorkCentre 5687 Family